Modefo's Heli RC Helicopters, Upgrades, Parts,Electronics

Safety Notes on Lithium Polymer ,Rc Heli's and products Safety in using Polymer cells or assemblies is your first priority.
If you cannot comply with the safe handling of Polymer cells or assemblies then do not use them.
If you do not understand the characteristics of Polymer cells or assemblies then do not use them. Please be sure to read and follow these instructions carefully.
Injury can occur if requirements are not followed.

Safe Charging
Lithium Polymer cells have very strict charging requirements.
Always charge Lithium Polymer cells or packs with recommended PCM or great damage may occur.
Always use chargers specifically approved for Lithium Polymer cells or packs.
Always test your charger to assure it is functioning properly.
Always charge your Lithium Polymer cells or packs outdoors and in a fire proof container.
Always store Lithium Polymer cells or packs in a fire proof container.
Always have sand or dry fire extinguisher handy in the event of fire.
Always keep any battery out of the reach of children.
Always handle Lithium Polymer cells and packs with great care.
Always purchase a factory authorized built pack instead of building your own.
Always observe the correct polarity when connecting cells or packs to charger or application.
Always seek medical attention if electrolyte gets in your eyes (flush with cold water immediately).
Always scrub with soap and water if electrolyte comes in contact with your skin.

Never charge Lithium Polymer cells or packs unattended.
Never charge Lithium Polymer beyond factory specifications and is strictly prohibited.
Never charge Lithium Polymer in your car, home or garage or where other physical damage can occur.
Never charge Lithium Polymer while in the application as the hot pack may ignite certain materials.
Never charge Lithium Polymer on flammable materials such as wood, foam or plastic.
Never extinguish a Lithium Polymer fire with water.
Never disassemble a Lithium Polymer cell or pack (see Damaged notes below).
Never short circuit Lithium Polymer cells or packs.
Never use a Lithium Polymer cell or pack that has been damaged (see Damaged notes below).
Never put loose cells with uncovered terminals in your pocket, purse, bag, desk drawer, etc.
Never keep cells or packs in temperatures that exceed 60C/140F.
Never exceed the factories maximum allowed discharge rates.
Never combine different cell sizes or capacities together in the same pack
Never unplug Battery from PCM while charging (Unplug charger before disconnecting Battery).

Damaged cells or packs
In the event your cells or packs were involved in a crash.....
Totally inspect the cells, wire leads and connections for possible short circuit.
If there is any doubt completely cut all wires from the cells and pack.
If any cells are dented or deformed do not use the pack again ever.
Follow disposal notes below.

Disposal of cells or packs
Discharge all cells individually to recommended cut-off voltage of 3.0 volts per cell.
Caution!! Cells may be warm or hot as usual during this discharge process.
After cooling, puncture small hole in cells and immerse in salt water for several hours.
Apply tape over one terminal and dispose of in trash.

As like any standard chemicals you use or store around work or home,
Follow all safety directions to prevent accidents or damage to persons or property.

Safety must be your first priority when using Lithium Polymer cells or packs.
Educate yourself, Educate your friends
And implement safe handling and usage of all Polymer Batteries.

Lithium Polymer Batteries distributed by Modefo's Heli are approved only for the Radio-Control Market.
Use in any other application is not permitted without prior approval.
Charging, discharging, use for Electric Motors and Flying Models may cause serious personal injury or property damage.
In purchasing/using Polymer Batteries RC Helicopters and products from Modefo's Heli, the buyer/user, agrees to accept all responsibilities of these risks
and not to hold Modefo's Heli, manufacturer, its Distributors or Retailers (owners and employees) responsible for
any accidents, injury to persons, or damage to property.

Since many Radio-Controlled applications exceed the manufacturer's recommended maximum discharge rates there
is no warranty (expressed or implied) by the manufacturer, its Distributors and Retailers in respect to the
Cycle Life, Capacity, Cell Characteristics or Storage of cells/packs used in the Radio-Controlled market.