Modefo's Heli RC Helicopters, Upgrades, Parts,Electronics

Quantity:

KR910003A BATT/DEV Connector

Details:

BATT/DEV Gilt Terminal Welding and Assembly:

Step 1?FFirst strip the wire about the length of 5mm?Cthen tin on the stripped wire by using 60W soldering iron.	Step 2?FSee above picture. Before tinning, melt the tin into the bottom about 80% full. Please note to take it slowly or it will full of the air inside to cause false welding.

Step 3?FPut the stripped wire into the tin hole. Follow the above picture soldering iron from the side to heat and melt the tin to wrap the wire. Please do not to spill the tin on the outside or it will not able to be put into the blue connector.	Step 4?FWait the gilt terminal cooling, put it through the blue connector, please note the polarity. Prepare a flat screwdriver as a tool to press the terminal.

Step 5?FAfter putting the terminal into the connector, use a small flat screwdriver to press at the end of the terminal.	Step 6?FUse a tool to slightly beat the gilt terminal into the connector joint.

Step7?FCheck if the terminal is on a proper position. When rotating the wire, the terminal should be followed to rotate.
Instructions:	Spcification:
	3.5mm connector, max continuous current:80A Note: 3.5mm Male gold connector for putting into "DEV" blue connector 3.5mm Female gold connector for putting into "BATT" blue connecotr